£11.95 Ex VAT
- Inc VAT: £14.34
- In Stock Ready To Be Dispatched.
- Secure Shopping High Security Checkout.
- Dispatches In: 3 - 5 Days
- Manufacturer: Start Traffic
Walking Man Symbol Car Park Marking
The walking man marking when used in a carpark is often there to indicate to motorists that pedestrians may be walking in this area. It is also frequently seen in distribution hubs to indicate areas where pedestrians have priority over vehicles.
Our thermoplastic walking man symbol is fast and easy to apply, allowing you to create quick and easy pedestrian safety areas. If purchased alongside our thermoplastic rolls a complete path marking system can easily be created. The rolls allow you to create clean outlines that pedestrians know to stay within.
We have these markings available in various sizes and colours, these can be used alongside arrows or exit signage to indicate proper evacuation routes in large complexes.
Key Features Of Our Thermoplastic Walking Man Floor Path Marking
- Easy Application - No special knowledge, talent or years at art school required, just a clean surface and a gas heat gun.
- Professional Appearance - These markings always look good due to their pre-cut design.
- Fast To Install - Minimal surface preparation is required for these markings, with a worst-case scenario requiring an application of primer.
- Non-Slip - Apply glass bead to enhance the traction of your marking, both for pedestrians and vehicles.
- Conforms - BSEN 1871
Choose From A Variety Of Colours
We have white and yellow markings ready to order online if you need other colours we are here to help. You may want to use these additional colours to mark our separate walkways to different areas of your operation or to dictate different levels of safety equipment requirements.
Application Of The Walking Man Symbol In Thermoplastic
Applying our walking man / pedestrian symbol markings is very easy. Firstly the area must be cleaned of all loose debris, oil, grease and salts. Once this is done you are ready to get going. If your road surface is old tarmac, concrete or block paving then you will need to use our fast-drying primer.
Once you have fully prepped the surface the marking can be set out. Once you are happy with the marking positioning a heat gun can be used to melt the marking to the road surface. For additional traction glass bead can be sprinkled over the surface, this is fused into the marking with the further application of heat.
Cannot find the bicycle symbol marking you are looking for? We are here to help, our trained staff are available throughout the day to take your calls or answer your messages. They will ensure that you get the best marking at the best price. Our phone lines are open during normal office hours.
Customers Who Viewed This Page Also Viewed
|Conforms||BS EN 1871|
|Application||If using glass bead, 250g of glass bead per square metre|
Customer Questions & Answers
Be the first to ask a question.